
D
CHANGE LOG
Revision D
2
3
4
1
2
3
4
5
6
7
8
9
10
11
12
Revised sub-heading font size and style throughout entire document.
Added GPIO[70], GPIO[71], and MFGI GPIO[72] to “Pin Assignment by SO/DIMM
Pin number” table in chapter 2.
Edited font style and size in all tables.
Corrected pin 38 of the Module/SO-DIMM Signal Characteristics table (changed
GPIO9230 to GPIO[23]).
Added GPIO [34] (12C serial clock line) and GPIO [65] (IRQ1) to Pin assignment
by GPIO table.
Changed GPIOP [68] to GPIO [68] in the Pin Assignment by GPIO table.
Corrected capitalization error in footer of document. Similarly corrected
revision discrepancy to reflect latest version (D).
Removed reference to a specific OS or folder (NET+OS) from the Using this
Guide chapter.
Revised the receive sensitivity data for WLAN in the Interfaces section and
WLAN in the Network Interface section.
Added note directly following the Pin assignment by SO-DIMM pin number table
explaining the special attention needed towards BUFFENR line (pin 8).
Corrected the labeling and descriptions of the Primary and Secondary antennas
for the RP-SMA and U.FL connectors.
Removed the note in the External Memory bus section within the Interfaces
section of Chapter 1.
Corrected naming and function errors relating to GPIO[18] and GPIO[23].
Revised the format of the VGA (enable) switch SW7 table to resemble the
format of the Serial Port B switch, SW2 table in the Switches and Buttons
section.
Added text stating that the address and data bus are now available on the
ConnectCore 9C also.
100
ConnectCore 9C/Wi -9C Hardware Reference, Rev D 05/2010